Sources and accuracy

Every chart on Utilunit is built from the standard that governs it (ISO, IEC, DIN/EN, ASME/ANSI, ASTM, SAE, JIS and others) and from manufacturer catalogues that implement those standards. Each chart lists its sources at the bottom of the page together with the date its values were last checked.

How values are checked

  • Values are compiled from the governing standard or a catalogue that reproduces it, then cross-checked against at least one independent source.
  • Where a value is calculated by a defined formula (AWG diameters, ISO paper sizes, tire diameters), the formula is stated on the page and the published rounded values are used where they exist.
  • Where values vary between manufacturers (load ratings, container tare weights, battery capacities), they are labelled as typical or left out.
  • Drawings and tables are generated from the same data file, so a drawing cannot contradict its table.

Units and rounding

Values are stored in the unit the standard uses and converted for display: 1 in = 25.4 mm exactly. Converted values are rounded sensibly for their size; the value in the standard's own unit is the authoritative one.

Standards and copyright

Standards documents are copyrighted by their publishers and many are sold. Utilunit does not reproduce standards text. Dimensions are facts; we present them in our own tables, drawings and explanations, and link to the publisher so you can buy the current edition when you need the full requirements.

Limits

Utilunit is a reference for identification, planning and everyday work. It is not a substitute for the current edition of a standard or the manufacturer's drawing for safety-critical or production use. Always confirm critical dimensions and tolerances at the source.

Reporting an error

If you find an error, write to contact@utilunit.com with the page and, ideally, the source. We fix confirmed errors promptly.