Golf Club Length and Loft Chart
Typical men's club lengths, with lofts where a published chart gives a typical value. A standard 7-iron is about 37 in long and a driver about 45 in; each iron is ½ in shorter than the one before. Makers differ, so compare the spec sheet of the set you buy.
Size chartSort by any column, or filter to find a row
| Club | LLength (men's standard)mmin | Loft° |
|---|---|---|
| Driver, woods and hybrids | ||
| Driver | 1143.045 | 9–12 |
| 3-wood | 1092.243 | 15 |
| 5-wood | 1066.842 | 18 |
| 3-hybrid | 1016.040 | — |
| Irons | ||
| 4-iron | 977.938.5 | — |
| 5-iron | 965.238 | — |
| 6-iron | 952.537.5 | — |
| 7-iron | 939.837 | — |
| 8-iron | 927.136.5 | — |
| 9-iron | 914.436 | — |
| Wedges and putter | ||
| Pitching wedge | 901.735.5 | 44–48 |
| Sand wedge | 895.3–901.735.25–35.5 | — |
| Putter | 863.6–889.034–35 | — |
No exact match. The nearest sizes:
Length, loft and lie
Length: each iron is ½ in shorter than the next longer one. Iron lengths are for steel shafts; woods and hybrids are given with graphite shafts, as on standard length charts.
Loft is the face angle from vertical. Lofts differ between makers and models, so only typical values from a published loft chart are listed.
Lie is the angle between the shaft and the ground when the sole sits flat. It differs between makers and models, so no typical values are listed.
About Golf Clubs
The Rules of Golf limit club length to 48 in (putters excepted).
Questions
How long is a standard driver?
Most men's drivers are 45 in (114 cm). The Rules of Golf allow up to 48 in.
What length is a standard 7-iron?
About 37 in (94 cm) for a men's steel-shafted 7-iron.
What is the loft of a pitching wedge?
Typically 44–48°.
Sources
- USGA / R&A: Equipment Rules, Part 2 Clubs (length limit 48 in)
- Hireko Golf: Standard golf club length chart
- CaddieHQ: What is standard golf club length
- Mitchell Golf: Golf club loft chart (old and modern average lofts)
Values last checked against these sources on November 15, 2026. · How we check data
Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.