USB Mini-B Pinout
Connector Pinouts · USB and phone connectors
The USB Mini-B has 5 contacts. Specification: USB 2.0 Specification, Mini-B ECN (USB-IF). The drawing shows the connector face with every pin colour-coded by function; the table below lists each pin's signal and description.
- Pins
- 5
- WWidth
- 6.85 mm0.270 in0.270 in6.85 mm
- HHeight
- 3 mm0.118 in0.118 in3 mm
Drawing
USB Mini-B specifications
| Pins | 5 |
|---|---|
| Standard | USB 2.0 Specification, Mini-B ECN (USB-IF) |
| WWidth | 6.85 mm0.270 in |
| HHeight | 3 mm0.118 in |
| Size refers to | Receptacle opening |
| Max. data rate | 480 Mbit/s (High-Speed) |
| Power | 5 V |
| Drawing view | Looking into the receptacle (port) |
USB Mini-B pin assignment
| Pin | Signal | Function | Wire |
|---|---|---|---|
| 1 | VBUS | +5 V supply | red |
| 2 | D− | USB 2.0 data, negative | white |
| 3 | D+ | USB 2.0 data, positive | green |
| 4 | ID | On-The-Go ID: tied to ground in an A plug, open in a B plug | |
| 5 | GND | Ground (power return) | black |
Pin 4 (ID) is unused in a normal cable. In USB On-The-Go it is grounded in a Mini-A plug to make the device the host. Mini-B has largely been replaced by Micro-B and USB-C.
Related connectors
All connector pinouts
Sources
- USB-IF: USB Type-C Cable and Connector Specification, Release 2.x
- USB-IF: Universal Serial Bus 2.0 / 3.2 Specifications
- HDMI Licensing Administrator: HDMI Specification 2.1 (connector and pin assignment)
- VESA: DisplayPort Standard
- ANSI/TIA-568: Commercial Building Telecommunications Cabling Standard (T568A/T568B)
- Intel: ATX Version 3.1 Multi Rail Desktop Platform Power Supply Design Guide
- PCI-SIG: PCI Express Card Electromechanical Specification 5.1
- NVIDIA: Power guidelines for professional GPUs (PCIe 6/8-pin pinout, DA-07261)
- SATA-IO: Serial ATA Revision 3.x
- Apple Lightning pin assignment (reverse engineered): nyansatan.github.io/lightning
Values last checked against these sources on November 15, 2026. · How we check data
Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.