Glove Size Chart: EN 420 Sizes 6–11, Hand Circumference, XS–XXL

The glove size number is the hand circumference in inches, measured around the knuckles without the thumb: size 8 = 8 in = 203 mm, which work gloves label M. EN 420 also sets the hand length (182 mm for size 8) and a minimum glove length.

11 sizesChecked 2026-11-153 sources

Glove size chartHalf sizes: circumference = size in inches

11 of 11
SizeHand circumferencemminHand lengthmminMinimum glove lengthmminLetter
EN 420 / EN ISO 21420 sizes
61526.01606.32208.7XS
71787.01716.72309.1S
82038.01827.22409.4M
92299.01927.62509.8L
1025410.02048.026010.2XL
1127911.02158.527010.6XXL
Half sizes (dress gloves)
6.51656.5———
7.51917.5———
8.52168.5———
9.52419.5———
10.526710.5———

How glove sizes are defined

EN 420 / EN ISO 21420 (protective gloves) defines sizes 6 to 11 by hand circumference and hand length, and requires each size to have a minimum glove length (220 mm for size 6 up to 270 mm for size 11). Work and safety gloves carry this number, often with a letter.

Dress and fashion gloves use the same number as inches of circumference and add half sizes: 7½ for a 7½ in (19 cm) hand. Women's leather gloves typically run 6–8½, men's 7½–10.

Letters usually map XS = 6, S = 7, M = 8, L = 9, XL = 10, XXL = 11. Sports gloves (golf, cycling, ski) use their own letter charts; check them.

About Glove Sizes

To measure circumference, hold the hand flat with fingers together and wrap a soft tape around the widest part of the palm, across the knuckles, leaving the thumb out. For hand length, measure from the crease of the wrist to the tip of the middle finger.

Leather stretches about half a size; nitrile and latex disposable gloves follow the same sizes but are snug by design. For winter gloves with liners, size up by half to one size.

Questions

What size glove is 8 inches around?

Size 8 (M). EN 420 size 8 is a 203 mm circumference and 182 mm hand length.

What is glove size 9 in cm?

Hand circumference 22.9 cm (229 mm), hand length 19.2 cm. Usually labelled L.

Is EN 420 still valid?

It was replaced by EN ISO 21420:2020, which kept the same size table.

What glove size is medium?

Size 8 in work gloves: about 8 in (20.3 cm) around the knuckles.

Sources

  1. EN ISO 21420:2020, Protective gloves, general requirements (replaces EN 420; size table)
  2. EN 420 size chart as published by glove makers (Showa, Portwest)
  3. Sinatec: glove sizes according to EN 420

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.