DIN 471 – 30 mm Circlip Groove Dimensions

Retaining Rings · DIN 471: external rings for shafts

The DIN 471 – 30 mm ring (DIN 471: external rings for shafts) needs a groove 28.6 mm (1.126 in) in diameter and at least 1.6 mm (0.0630 in) wide. The ring itself is 1.5 mm (0.0591 in) thick.

d2Groove diameter
28.6 mm1.126 in1.126 in28.6 mm
mGroove width (min)
1.6 mm0.0630 in0.0630 in1.6 mm
sRing thickness
1.5 mm0.0591 in0.0591 in1.5 mm

Drawing

⌀30 mm⌀1.181 in
m 1.6 mmm 0.0630 int 0.7 mmt 0.0276 ins 1.5 mms 0.0591 inShaft surfacegroove ⌀28.6 mmgroove ⌀1.126 in
Left: ring outline schematic, diameter to scale. Right: groove detail, magnified.Proportions shown, not to scale · Dimensions in mmDimensions in inches

DIN 471 – 30 mm specifications

d1Shaft / bore diameter30 mm1.181 in
d2Groove diameter28.6 mm1.126 in
mGroove width (min)1.6 mm0.0630 in
sRing thickness1.5 mm0.0591 in

Same size for the other side (shaft ↔ bore)

All Retaining Rings sizes

Compare all 126 sizes in the Retaining Rings chart →

Sources

  1. DIN 471:2011, Retaining rings for shafts, normal type and heavy type
  2. DIN 472:2011, Retaining rings for bores, normal type and heavy type
  3. DIN 6799:2017, Retaining washers for shafts (E-rings)
  4. Westfield Fasteners: External circlips DIN 471 table
  5. Westfield Fasteners: E-clips DIN 6799 table
  6. AmesWeb: Internal circlip dimensions for bores (DIN 472)
  7. Würth: Circlips DIN 471, product data

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.