DIN 471 – 65 mm Circlip Groove Dimensions

Retaining Rings · DIN 471: external rings for shafts

The DIN 471 – 65 mm ring (DIN 471: external rings for shafts) needs a groove 62 mm (2.441 in) in diameter and at least 2.65 mm (0.1043 in) wide. The ring itself is 2.5 mm (0.0984 in) thick.

d2Groove diameter
62 mm2.441 in2.441 in62 mm
mGroove width (min)
2.65 mm0.1043 in0.1043 in2.65 mm
sRing thickness
2.5 mm0.0984 in0.0984 in2.5 mm

Drawing

⌀65 mm⌀2.559 in
m 2.65 mmm 0.1043 int 1.5 mmt 0.0591 ins 2.5 mms 0.0984 inShaft surfacegroove ⌀62 mmgroove ⌀2.441 in
Left: ring outline schematic, diameter to scale. Right: groove detail, magnified.Proportions shown, not to scale · Dimensions in mmDimensions in inches

DIN 471 – 65 mm specifications

d1Shaft / bore diameter65 mm2.559 in
d2Groove diameter62 mm2.441 in
mGroove width (min)2.65 mm0.1043 in
sRing thickness2.5 mm0.0984 in

Same size for the other side (shaft ↔ bore)

All Retaining Rings sizes

Compare all 126 sizes in the Retaining Rings chart →

Sources

  1. DIN 471:2011, Retaining rings for shafts, normal type and heavy type
  2. DIN 472:2011, Retaining rings for bores, normal type and heavy type
  3. DIN 6799:2017, Retaining washers for shafts (E-rings)
  4. Westfield Fasteners: External circlips DIN 471 table
  5. Westfield Fasteners: E-clips DIN 6799 table
  6. AmesWeb: Internal circlip dimensions for bores (DIN 472)
  7. Würth: Circlips DIN 471, product data

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.