DIN 471 – 9 mm Circlip Groove Dimensions

Retaining Rings · DIN 471: external rings for shafts

The DIN 471 – 9 mm ring (DIN 471: external rings for shafts) needs a groove 8.6 mm (0.339 in) in diameter and at least 1.1 mm (0.0433 in) wide. The ring itself is 1 mm (0.0394 in) thick.

d2Groove diameter
8.6 mm0.339 in0.339 in8.6 mm
mGroove width (min)
1.1 mm0.0433 in0.0433 in1.1 mm
sRing thickness
1 mm0.0394 in0.0394 in1 mm

Drawing

⌀9 mm⌀0.354 in
m 1.1 mmm 0.0433 int 0.2 mmt 0.0079 ins 1 mms 0.0394 inShaft surfacegroove ⌀8.6 mmgroove ⌀0.339 in
Left: ring outline schematic, diameter to scale. Right: groove detail, magnified.Proportions shown, not to scale · Dimensions in mmDimensions in inches

DIN 471 – 9 mm specifications

d1Shaft / bore diameter9 mm0.354 in
d2Groove diameter8.6 mm0.339 in
mGroove width (min)1.1 mm0.0433 in
sRing thickness1 mm0.0394 in

Same size for the other side (shaft ↔ bore)

All Retaining Rings sizes

Compare all 126 sizes in the Retaining Rings chart →

Sources

  1. DIN 471:2011, Retaining rings for shafts, normal type and heavy type
  2. DIN 472:2011, Retaining rings for bores, normal type and heavy type
  3. DIN 6799:2017, Retaining washers for shafts (E-rings)
  4. Westfield Fasteners: External circlips DIN 471 table
  5. Westfield Fasteners: E-clips DIN 6799 table
  6. AmesWeb: Internal circlip dimensions for bores (DIN 472)
  7. Würth: Circlips DIN 471, product data

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.