6.35 mm (1/4 in) TRS: Pinout and Size

Audio Jacks & Connectors · Phone plugs (jacks)

The 6.35 mm (1/4 in) TRS plug is 6.35 mm (0.250 in) in diameter with 3 contacts. Signal: Stereo or balanced mono. Typical use: Studio headphones, balanced line (mixers, monitors), insert cables. Reference: 1/4 in phone plug (A-gauge pattern; B-gauge is the older balanced/patch type).

dPlug diameter
6.35 mm0.250 in0.250 in6.35 mm
Contacts
3

Drawing

TipHot (+)RingCold (−)SleeveGround6.35 mm0.250 in
Contact order of the plug, schematic; only the diameter is a real dimension.Proportions shown, not to scale · Dimensions in mmDimensions in inches

6.35 mm (1/4 in) TRS specifications

dPlug diameter6.35 mm0.250 in
Contacts3
SignalStereo or balanced mono
Typical useStudio headphones, balanced line (mixers, monitors), insert cables
Standard1/4 in phone plug (A-gauge pattern; B-gauge is the older balanced/patch type)

6.35 mm (1/4 in) TRS pinout

ContactSignalFunction
TipHot (+)Balanced mono: in-phase signal, or left channel on stereo headphones
RingCold (−)Balanced mono: inverted signal, or right channel on stereo headphones
SleeveGroundShield / ground

Also the classic stereo headphone plug of hi-fi amplifiers. On mixers and audio interfaces the same socket is usually a balanced line input or output.

Same plug diameter

All audio connectors

All 13 connectors in the Audio Jacks & Connectors chart →

Sources

  1. EIA RS-453 / IEC 60603-11: concentric phone plugs (0.206 in type); MIL-DTL-642 telephone plugs
  2. JEITA RC-8141C: 4.4 mm 5-pole (Pentaconn) headphone plug; Nippon DICS Pentaconn product data
  3. IEC 60268-12 / AES14: Application of connectors for broadcast and audio (XLR pin 1 shield, 2 hot, 3 cold)
  4. Neutrik: XLR and speakON (NL2, NL4) connector data sheets and wiring
  5. Switchcraft: 1/4 in and 3.5 mm phone plug drawings
  6. Wikipedia: Phone connector (audio): CTIA vs OMTP TRRS, balanced conventions

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.