40 mm fan: Hole Spacing and Dimensions

Case Fan Sizes

A 40 mm fan has a 40 mm (1.57 in) square frame. Mounting-hole spacing, centre to centre: 32 mm (1.26 in). Common frame thicknesses are 10, 20, 28 mm. Typical use: Small form factor, chipset and VRM coolers, 1U servers, 3D printers.

AFrame size
40 mm1.57 in1.57 in40 mm
BHole spacing (centre to centre)
32 mm1.26 in1.26 in32 mm

Drawing

32 mm1.26 in32 mm1.26 in40 mm1.57 in
Frame and hole spacing in proportion; blades, hub and hole size indicative.Drawn to scale · Dimensions in mmDimensions in inches

40 mm fan specifications

AFrame size40 mm1.57 in
BHole spacing (centre to centre)32 mm1.26 in
Common thicknesses10, 20, 28 mm
Typical useSmall form factor, chipset and VRM coolers, 1U servers, 3D printers

3-pin and 4-pin fan connector pinout

PinSignalFunctionTypical wire colour
1GNDGroundblack
2+12 VSupply (on 3-pin fans the board varies this voltage to control speed)red or yellow
3Sense (tach)Speed signal, 2 pulses per revolutionyellow or green
4PWM control25 kHz PWM speed control (4-pin fans only)blue

Small fans spin fast (5000–10000 rpm and more in servers) and are the loudest per airflow. 3D printers commonly use 40 × 10 mm fans at 12 or 24 V.

Next smaller and larger fan

All fan sizes

All 10 fan sizes in the Case Fan Sizes chart →

Sources

  1. Arctic: Fan mounting hole pattern drawings (40 mm, 120 mm, 140 mm)
  2. Noctua: 120 mm and 140 mm fan mounting (NF-P14 / NF-A14 dual hole pattern)
  3. Intel: 4-Wire Pulse Width Modulation (PWM) Controlled Fans specification, rev. 1.3
  4. Voltcave: How to measure a PC fan's size (fan size vs hole spacing table)
  5. Wikipedia: Computer fan (fan size vs mounting hole spacing table, connectors)

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.