1/2" Copper Tube Size

Copper Tube · ASTM B88: US copper water tube (nominal inch sizes)

1/2" copper tube (ASTM B88: US copper water tube, nominal inch sizes) has an outside diameter of 15.88 mm (0.625 in). Wall thickness, inside diameter and weight depend on the tube type and are listed below; the drawing shows the cross-section to scale.

ODOutside diameter
15.88 mm0.625 in0.625 in15.88 mm
tWall, Type L
1.02 mm0.040 in0.040 in1.02 mm
IDInside diameter, Type L
13.84 mm0.545 in0.545 in13.84 mm
Weight, Type L
0.424 kg/m0.285 lb/ft0.285 lb/ft0.424 kg/m

Drawing

⌀15.88 mm⌀0.625 in⌀13.84 mm⌀0.545 int = 1.02 mmt = 0.040 inSection shown: Type L
Wall by type (enlarged)M0.71 mm0.028 inL1.02 mm0.040 inK1.25 mm0.049 in
Hatched ring: Type L wall; dashed circle: Type K bore. Bar view: every type made in this size, enlarged to one scale.Drawn to scale · Dimensions in mmDimensions in inches

1/2" specifications

ODOutside diameter15.88 mm0.625 in
tWall, Type K1.25 mm0.049 in
tWall, Type L1.02 mm0.040 in
tWall, Type M0.71 mm0.028 in
IDInside diameter, Type K13.39 mm0.527 in
IDInside diameter, Type L13.84 mm0.545 in
IDInside diameter, Type M14.45 mm0.569 in
Weight, Type K0.344 lb/ft0.512 kg/m
Weight, Type L0.285 lb/ft0.424 kg/m
Weight, Type M0.204 lb/ft0.304 kg/m

1/2" copper is 5/8" (0.625 in, 15.9 mm) outside. Type L: wall 0.040 in, ID 0.545 in; Type M: wall 0.028 in, ID 0.569 in. It is close to metric 15 mm but not interchangeable.

Steel/PVC pipe of the same nominal size (larger OD)

All Copper Tube sizes

Compare all 19 sizes in the Copper Tube chart →

Sources

  1. ASTM B88: Standard Specification for Seamless Copper Water Tube
  2. Copper Development Association: The Copper Tube Handbook (Table 14.3, dimensions and weights)
  3. EN 1057:2006+A1:2010, Copper and copper alloys, seamless round copper tubes for water and gas in sanitary and heating applications

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.