324T Motor Frame Dimensions

Motor Frame Sizes · NEMA MG 1 (inch)

The 324T frame (NEMA MG 1, inch) has a shaft height of 8 in (203.2 mm) and a 2 1/8 in (54 mm) shaft 5 1/4 in (133.4 mm) long. Foot holes: 12 1/2 in (317.5 mm) across × 10 1/2 in (266.7 mm) along, the first one 5 1/4 in (133.4 mm) from the shaft shoulder; hole diameter 21/32 in (16.7 mm).

HShaft height (IEC H / NEMA D)
203.2 mm8 in8 in203.2 mm
DShaft diameter (IEC D / NEMA U)
54 mm2 1/8 in2 1/8 in54 mm
AFoot holes across (IEC A / NEMA 2E)
317.5 mm12 1/2 in12 1/2 in317.5 mm
BFoot holes along (IEC B / NEMA 2F)
266.7 mm10 1/2 in10 1/2 in266.7 mm

Drawing

Drive-end view2E = 317.5 mm2E = 12 1/2 inD = 203.2 mmD = 8 in
Side view2F = 266.7 mm2F = 10 1/2 inBA = 133.4 mmBA = 5 1/4 inN-W = 133.4 mmN-W = 5 1/4 inU = 54 mmU = 2 1/8 in
Mounting dimensions to scale for this frame; body, fan cowl and terminal box are schematic.Drawn to scale · Dimensions in mmDimensions in inches

324T specifications

HShaft height (IEC H / NEMA D)203.2 mm8 in
AFoot holes across (IEC A / NEMA 2E)317.5 mm12 1/2 in
BFoot holes along (IEC B / NEMA 2F)266.7 mm10 1/2 in
CShaft shoulder to first hole (IEC C / NEMA BA)133.4 mm5 1/4 in
KFoot bolt hole (IEC K / NEMA H)16.7 mm21/32 in
DShaft diameter (IEC D / NEMA U)54 mm2 1/8 in
EShaft extension (IEC E / NEMA N-W)133.4 mm5 1/4 in

Same shaft height, other foot length

Similar shaft height in the other system

All motor frames

All 48 motor frames →

Sources

  1. IEC 60072-1:2022, Dimensions and output series for rotating electrical machines, Part 1: Frame numbers 56 to 400
  2. NEMA MG 1: Motors and Generators, Part 4 (dimensions, frame designations)
  3. Regal Rexnord: Quick reference motor dimensions (NEMA frame chart)
  4. Motion Industries: NEMA quick reference chart
  5. Electric Motor Warehouse / Drive Centre: IEC quick reference dimensional charts
  6. ABB / WEG / Brook Crompton low-voltage motor catalogues: IEC dimension tables

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.