1-1/4" square Parallel Key and Keyway Dimensions

Parallel Keys · Inch: ANSI B17.1 square keys

A 1-1/4" square key (ANSI B17.1) is used on shafts over 4-1/2 in up to 5-1/2 in. The keyseat is cut 0.625 in deep in both shaft and hub, half the key height.

dShaft diameter (over – up to)
114.3–139.7 mm4.500–5.500 in4.500–5.500 in114.3–139.7 mm
bWidth
31.75 mm1 1/4 in1 1/4 in31.75 mm
t1Shaft keyway depth
15.88 mm5/8 in5/8 in15.88 mm
t2Hub keyway depth
15.88 mm5/8 in5/8 in15.88 mm

Drawing

b 31.75 mmb 1 1/4 int1 15.88 mmt1 5/8 int2 15.88 mmt2 5/8 in⌀127 mm⌀5 in
Shaft at the middle of the range; keyseats at half the key height (ANSI B17.1)Drawn to scale · Dimensions in mmDimensions in inches

1-1/4" square specifications

dShaft diameter (over – up to)114.3–139.7 mm4.500–5.500 in
bWidth31.75 mm1 1/4 in
hHeight31.75 mm1 1/4 in
t1Shaft keyway depth15.88 mm5/8 in
t2Hub keyway depth15.88 mm5/8 in

All Parallel Keys sizes

Compare all 29 sizes in the Parallel Keys chart →

Sources

  1. DIN 6885-1:2021, Parallel keys, keyways, deep pattern: dimensions, tolerances, mass
  2. ANSI B17.1: Keys and keyseats (square and flat parallel keys)
  3. fasten.it: DIN 6885-1 dimension table
  4. Böllhoff: DIN 6885 steel parallel keys data sheet
  5. Gantner: DIN 6885 parallel keys

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.