5/8" square Parallel Key and Keyway Dimensions

Parallel Keys · Inch: ANSI B17.1 square keys

A 5/8" square key (ANSI B17.1) is used on shafts over 2-1/4 in up to 2-3/4 in. The keyseat is cut 0.3125 in deep in both shaft and hub, half the key height.

dShaft diameter (over – up to)
57.15–69.85 mm2.250–2.750 in2.250–2.750 in57.15–69.85 mm
bWidth
15.88 mm5/8 in5/8 in15.88 mm
t1Shaft keyway depth
7.94 mm5/16 in5/16 in7.94 mm
t2Hub keyway depth
7.94 mm5/16 in5/16 in7.94 mm

Drawing

b 15.88 mmb 5/8 int1 7.94 mmt1 5/16 int2 7.94 mmt2 5/16 in⌀63.5 mm⌀2 1/2 in
Shaft at the middle of the range; keyseats at half the key height (ANSI B17.1)Drawn to scale · Dimensions in mmDimensions in inches

5/8" square specifications

dShaft diameter (over – up to)57.15–69.85 mm2.250–2.750 in
bWidth15.88 mm5/8 in
hHeight15.88 mm5/8 in
t1Shaft keyway depth7.94 mm5/16 in
t2Hub keyway depth7.94 mm5/16 in

All Parallel Keys sizes

Compare all 29 sizes in the Parallel Keys chart →

Sources

  1. DIN 6885-1:2021, Parallel keys, keyways, deep pattern: dimensions, tolerances, mass
  2. ANSI B17.1: Keys and keyseats (square and flat parallel keys)
  3. fasten.it: DIN 6885-1 dimension table
  4. Böllhoff: DIN 6885 steel parallel keys data sheet
  5. Gantner: DIN 6885 parallel keys

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.