7/8" square Parallel Key and Keyway Dimensions

Parallel Keys · Inch: ANSI B17.1 square keys

A 7/8" square key (ANSI B17.1) is used on shafts over 3-1/4 in up to 3-3/4 in. The keyseat is cut 0.4375 in deep in both shaft and hub, half the key height.

dShaft diameter (over – up to)
82.55–95.25 mm3.250–3.750 in3.250–3.750 in82.55–95.25 mm
bWidth
22.23 mm7/8 in7/8 in22.23 mm
t1Shaft keyway depth
11.11 mm7/16 in7/16 in11.11 mm
t2Hub keyway depth
11.11 mm7/16 in7/16 in11.11 mm

Drawing

b 22.23 mmb 7/8 int1 11.11 mmt1 7/16 int2 11.11 mmt2 7/16 in⌀88.9 mm⌀3 1/2 in
Shaft at the middle of the range; keyseats at half the key height (ANSI B17.1)Drawn to scale · Dimensions in mmDimensions in inches

7/8" square specifications

dShaft diameter (over – up to)82.55–95.25 mm3.250–3.750 in
bWidth22.23 mm7/8 in
hHeight22.23 mm7/8 in
t1Shaft keyway depth11.11 mm7/16 in
t2Hub keyway depth11.11 mm7/16 in

All Parallel Keys sizes

Compare all 29 sizes in the Parallel Keys chart →

Sources

  1. DIN 6885-1:2021, Parallel keys, keyways, deep pattern: dimensions, tolerances, mass
  2. ANSI B17.1: Keys and keyseats (square and flat parallel keys)
  3. fasten.it: DIN 6885-1 dimension table
  4. Böllhoff: DIN 6885 steel parallel keys data sheet
  5. Gantner: DIN 6885 parallel keys

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.