G 1/2 BSP Thread Dimensions

Pipe Threads · BSP: British pipe thread, ISO 228 G / ISO 7 R, Rp, Rc

G 1/2 BSP (BSP: British pipe thread, ISO 228 G / ISO 7 R, Rp, Rc) has 1.814 mm (14 TPI) and an outside diameter of about 20.955 mm (0.825 in). Thread form: G parallel (ISO 228) or R/Rc tapered 1:16 (ISO 7); Rp parallel internal, 55° flank angle. Engagement length 8.2 mm (0.323 in).

nThreads per inch
1.814 mm14 TPI14 TPI1.814 mm
DOutside diameter (pipe OD / major Ø)
20.955 mm0.825 in0.825 in20.955 mm
L₁Engagement length (NPT L1 hand-tight / ISO 7 gauge length)
8.2 mm0.323 in0.323 in8.2 mm
Tap drill (typical)
19.0 mm

Drawing

gauge planeL₁ 8.2 mmL₁ 0.323 in⌀20.955 mm⌀0.825 inG: parallel · R: taper 1:16
55°P = 1.814 mmP = 14 TPIRounded crests and roots (Whitworth)
BSP: 55° Whitworth thread. G is parallel; R (external) and Rc (internal) taper 1:16 with the gauge length L₁ shown.Proportions shown, not to scale · Dimensions in mmDimensions in inches

G 1/2 BSP specifications

nThreads per inch14 TPI1.814 mm
DOutside diameter (pipe OD / major Ø)20.955 mm0.825 in
d₁Minor diameter18.632 mm0.734 in
L₁Engagement length (NPT L1 hand-tight / ISO 7 gauge length)8.2 mm0.323 in
Tap drill (typical)19.0 mm
Thread angle55°
FormG parallel (ISO 228) or R/Rc tapered 1:16 (ISO 7); Rp parallel internal

G 1/2 is the standard thread for European taps, shower hoses and radiator valves. Seal it with a flat washer or O-ring, not tape.

Also known as

G1/2R1/2Rp1/2Rc1/2

NPT thread of the same nominal size (not interchangeable)

All Pipe Threads sizes

Compare all 28 sizes in the Pipe Threads chart →

Sources

  1. ASME B1.20.1: Pipe Threads, General Purpose, Inch
  2. ISO 228-1:2000, Pipe threads where pressure-tight joints are not made on the threads
  3. ISO 7-1:1994, Pipe threads where pressure-tight joints are made on the threads
  4. Engineers Edge: Whitworth pipe thread (DIN ISO 228) tap drill table
  5. Machining Doctor: NPT thread charts (B1.20.1 basic dimensions)

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.