TO-252 (DPAK) Package Dimensions

SMD & IC Packages · Power SMD packages

The TO-252 (DPAK) package body is 6.6 mm (0.260 in) long and 6.1 mm (0.240 in) wide. See the drawing for the overall size over the leads and the pin pitch; the land pattern for your PCB comes from the part's datasheet.

LBody length
6.6 mm0.260 in0.260 in6.6 mm
WBody width
6.1 mm0.240 in0.240 in6.1 mm
ePitch
2.28 mm0.090 in0.090 in2.28 mm
Pins
3

Drawing

2.28 mm0.090 in6.6 mm0.260 in6.1 mm0.240 in9.35–10.4 mm0.368–0.409 in
Top view. Body, pitch and lead span to scale; lead widths and terminations are typical proportions.Drawn to scale · Dimensions in mmDimensions in inches

TO-252 (DPAK) specifications

LBody length6.6 mm0.260 in
WBody width6.1 mm0.240 in
EWidth over leads9.35–10.4 mm0.368–0.409 in
HHeight (max.; chips: typ.)2.39 mm0.094 in
ePitch2.28 mm0.090 in
Pins3
StandardJEDEC TO-252

Overall length (tab to lead tips) differs slightly between makers, hence the range. Two outer leads at 2 × 2.28 mm; the centre lead is cut short and connected to the tab. Typical for power MOSFETs and regulators up to a few watts.

Also known as

DPAKTO-252

All packages

All 49 packages in the SMD & IC Packages chart →

Sources

  1. JEDEC JEP95: JEDEC Registered and Standard Outlines for Semiconductor Devices
  2. IEC 60115-8 / EIA-576: Fixed chip resistors, case sizes
  3. Yageo: RC series general purpose chip resistors datasheet
  4. Vishay: CRCW thick film chip resistors datasheet
  5. Texas Instruments: Package outline drawings (DBV, DCK, D, PW, DGK, RGT, PM)
  6. Nexperia: Package information (SOT23, SOT323, SOT363, SOD123, SOD323, SOT89, SOT223)

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.