180 mm fan: Hole Spacing and Dimensions

Case Fan Sizes

A 180 mm fan has a 180 mm (7.09 in) square frame. Mounting-hole spacing, centre to centre: varies by maker. Common frame thicknesses are about 30–33 mm. Typical use: Large intake fans in some cases; mounting varies by maker.

AFrame size
180 mm7.09 in7.09 in180 mm
BHole spacing (centre to centre)
varies by maker

Drawing

No common hole pattern180 mm7.09 in
Frame and hole spacing in proportion; blades, hub and hole size indicative.Drawn to scale · Dimensions in mmDimensions in inches

180 mm fan specifications

AFrame size180 mm7.09 in
BHole spacing (centre to centre)varies by maker
Common thicknessesabout 30–33 mm
Typical useLarge intake fans in some cases; mounting varies by maker

3-pin and 4-pin fan connector pinout

PinSignalFunctionTypical wire colour
1GNDGroundblack
2+12 VSupply (on 3-pin fans the board varies this voltage to control speed)red or yellow
3Sense (tach)Speed signal, 2 pulses per revolutionyellow or green
4PWM control25 kHz PWM speed control (4-pin fans only)blue

Used by a few cases (for example some SilverStone models). There is no common hole pattern, so a replacement usually has to come from the case maker.

Next smaller and larger fan

All fan sizes

All 10 fan sizes in the Case Fan Sizes chart →

Sources

  1. Arctic: Fan mounting hole pattern drawings (40 mm, 120 mm, 140 mm)
  2. Noctua: 120 mm and 140 mm fan mounting (NF-P14 / NF-A14 dual hole pattern)
  3. Intel: 4-Wire Pulse Width Modulation (PWM) Controlled Fans specification, rev. 1.3
  4. Voltcave: How to measure a PC fan's size (fan size vs hole spacing table)
  5. Wikipedia: Computer fan (fan size vs mounting hole spacing table, connectors)

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.