Module 2.5 Gear Dimensions

Gear Modules · ISO 54 modules, series I and II

A Module 2.5 gear has a circular pitch of 7.854 mm (0.3092 in) and a whole tooth depth of 5.625 mm (0.2215 in), addendum 2.5 mm (0.0984 in), dedendum 3.125 mm (0.1230 in) on the ISO 53 basic rack with a 20° pressure angle. Pitch diameter = number of teeth × 2.5 mm. The equivalent diametral pitch is 10.16. The nearest inch gear, 10 DP, does not mesh with it.

mModule
2.5 mm0.0984 in0.0984 in2.5 mm
pCircular pitch (πm)
7.854 mm0.3092 in0.3092 in7.854 mm
hWhole depth (2.25 m)
5.625 mm0.2215 in0.2215 in5.625 mm
DPEquivalent diametral pitch (25.4/m)
10.16

Drawing

Pitch linep 7.854 mmp 0.3092 ins 3.927 mms 0.1546 inh 5.625 mmh 0.2215 inha 2.5 mmha 0.0984 inhf 3.125 mmhf 0.1230 in20°
Tip circlePitch circleBase circleRoot circle20-tooth gear, involute flanks
Proportions shown, not to scale · Dimensions in mmDimensions in inches

Module 2.5 specifications

mModule2.5 mm0.0984 in
SeriesI
pCircular pitch (πm)7.854 mm0.3092 in
sTooth thickness (πm/2)3.927 mm0.1546 in
haAddendum (1 m)2.5 mm0.0984 in
hfDedendum (1.25 m)3.125 mm0.1230 in
hWhole depth (2.25 m)5.625 mm0.2215 in
cBottom clearance (0.25 m)0.625 mm0.0246 in
DPEquivalent diametral pitch (25.4/m)10.16
Nearest standard DP10

Module 2.5 is the closest metric equivalent of 10 DP (10.16 DP). The tooth sizes differ by 1.6 %, which is enough to make the two jam or run rough over several teeth. Replace gears as pairs.

Also known as

M2.5MOD2.5

All gear modules

Compare all 37 modules in the Gear Modules chart →

Sources

  1. ISO 54:1996, Cylindrical gears for general engineering and for heavy engineering: Modules
  2. ISO 53:1998, Cylindrical gears for general and heavy engineering: Standard basic rack tooth profile
  3. DIN 780-1: Series of modules for gears (modules below 1 mm)
  4. KHK Gear Technical Reference: Module sizes and tooth profile

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.