444T Motor Frame Dimensions

Motor Frame Sizes · NEMA MG 1 (inch)

The 444T frame (NEMA MG 1, inch) has a shaft height of 11 in (279.4 mm) and a 3 3/8 in (85.7 mm) shaft 8 1/2 in (215.9 mm) long. Foot holes: 18 in (457.2 mm) across × 14 1/2 in (368.3 mm) along, the first one 7 1/2 in (190.5 mm) from the shaft shoulder; hole diameter 0.813 in (20.6 mm).

HShaft height (IEC H / NEMA D)
279.4 mm11 in11 in279.4 mm
DShaft diameter (IEC D / NEMA U)
85.7 mm3 3/8 in3 3/8 in85.7 mm
AFoot holes across (IEC A / NEMA 2E)
457.2 mm18 in18 in457.2 mm
BFoot holes along (IEC B / NEMA 2F)
368.3 mm14 1/2 in14 1/2 in368.3 mm

Drawing

Drive-end view2E = 457.2 mm2E = 18 inD = 279.4 mmD = 11 in
Side view2F = 368.3 mm2F = 14 1/2 inBA = 190.5 mmBA = 7 1/2 inN-W = 215.9 mmN-W = 8 1/2 inU = 85.7 mmU = 3 3/8 in
Mounting dimensions to scale for this frame; body, fan cowl and terminal box are schematic.Drawn to scale · Dimensions in mmDimensions in inches

444T specifications

HShaft height (IEC H / NEMA D)279.4 mm11 in
AFoot holes across (IEC A / NEMA 2E)457.2 mm18 in
BFoot holes along (IEC B / NEMA 2F)368.3 mm14 1/2 in
CShaft shoulder to first hole (IEC C / NEMA BA)190.5 mm7 1/2 in
KFoot bolt hole (IEC K / NEMA H)20.6 mm0.813 in
DShaft diameter (IEC D / NEMA U)85.7 mm3 3/8 in
EShaft extension (IEC E / NEMA N-W)215.9 mm8 1/2 in

Same shaft height, other foot length

Similar shaft height in the other system

All motor frames

All 48 motor frames →

Sources

  1. IEC 60072-1:2022, Dimensions and output series for rotating electrical machines, Part 1: Frame numbers 56 to 400
  2. NEMA MG 1: Motors and Generators, Part 4 (dimensions, frame designations)
  3. Regal Rexnord: Quick reference motor dimensions (NEMA frame chart)
  4. Motion Industries: NEMA quick reference chart
  5. Electric Motor Warehouse / Drive Centre: IEC quick reference dimensional charts
  6. ABB / WEG / Brook Crompton low-voltage motor catalogues: IEC dimension tables

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.