1/8-27 NPT Thread Dimensions

Pipe Threads · NPT: American taper pipe thread, ASME B1.20.1

1/8-27 NPT (NPT: American taper pipe thread, ASME B1.20.1) has 27 TPI (0.941 mm) and an outside diameter of about 10.287 mm (0.405 in). Thread form: Tapered 1:16 on diameter, 60° flank angle. Engagement length 4.1 mm (0.161 in).

nThreads per inch
0.941 mm27 TPI27 TPI0.941 mm
DOutside diameter (pipe OD / major Ø)
10.287 mm0.405 in0.405 in10.287 mm
L₁Engagement length (NPT L1 hand-tight / ISO 7 gauge length)
4.1 mm0.161 in0.161 in4.1 mm
Tap drill (typical)
R (0.339 in, 8.6 mm)

Drawing

gauge planeL₁ 4.1 mmL₁ 0.161 in⌀10.287 mm⌀0.405 inTaper 1:16 on diameter (exaggerated)
60°P = 0.941 mmP = 27 TPIFlat crests and roots (NPT)
NPT: 60° thread on a 1:16 taper. L₁ is the hand-tight engagement from the small end to the gauge plane.Proportions shown, not to scale · Dimensions in mmDimensions in inches

1/8-27 NPT specifications

nThreads per inch27 TPI0.941 mm
DOutside diameter (pipe OD / major Ø)10.287 mm0.405 in
L₁Engagement length (NPT L1 hand-tight / ISO 7 gauge length)4.1 mm0.161 in
L₂Effective thread length (L2)6.7 mm0.2639 in
Tap drill (typical)R (0.339 in, 8.6 mm)
Thread angle60°
FormTapered 1:16 on diameter

1/8-27 NPT is the common size for gauge ports, sensors and grease fittings. Its tap drill R (0.339 in) is often replaced by 11/32 in (0.344 in).

BSP thread of the same nominal size (not interchangeable)

Pipe this thread is cut on

All Pipe Threads sizes

Compare all 28 sizes in the Pipe Threads chart →

Sources

  1. ASME B1.20.1: Pipe Threads, General Purpose, Inch
  2. ISO 228-1:2000, Pipe threads where pressure-tight joints are not made on the threads
  3. ISO 7-1:1994, Pipe threads where pressure-tight joints are made on the threads
  4. Engineers Edge: Whitworth pipe thread (DIN ISO 228) tap drill table
  5. Machining Doctor: NPT thread charts (B1.20.1 basic dimensions)

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.