3/4-14 NPT Thread Dimensions

Pipe Threads · NPT: American taper pipe thread, ASME B1.20.1

3/4-14 NPT (NPT: American taper pipe thread, ASME B1.20.1) has 14 TPI (1.814 mm) and an outside diameter of about 26.670 mm (1.050 in). Thread form: Tapered 1:16 on diameter, 60° flank angle. Engagement length 8.6 mm (0.339 in).

nThreads per inch
1.814 mm14 TPI14 TPI1.814 mm
DOutside diameter (pipe OD / major Ø)
26.670 mm1.050 in1.050 in26.670 mm
L₁Engagement length (NPT L1 hand-tight / ISO 7 gauge length)
8.6 mm0.339 in0.339 in8.6 mm
Tap drill (typical)
59/64 in (23.4 mm)

Drawing

gauge planeL₁ 8.6 mmL₁ 0.339 in⌀26.670 mm⌀1.050 inTaper 1:16 on diameter (exaggerated)
60°P = 1.814 mmP = 14 TPIFlat crests and roots (NPT)
NPT: 60° thread on a 1:16 taper. L₁ is the hand-tight engagement from the small end to the gauge plane.Proportions shown, not to scale · Dimensions in mmDimensions in inches

3/4-14 NPT specifications

nThreads per inch14 TPI1.814 mm
DOutside diameter (pipe OD / major Ø)26.670 mm1.050 in
L₁Engagement length (NPT L1 hand-tight / ISO 7 gauge length)8.6 mm0.339 in
L₂Effective thread length (L2)13.9 mm0.5457 in
Tap drill (typical)59/64 in (23.4 mm)
Thread angle60°
FormTapered 1:16 on diameter

3/4-14 NPT (26.7 mm) and 3/4 BSP (26.44 mm) also share 14 TPI. Garden hose 3/4 GHT is a different thread (11.5 TPI, parallel).

BSP thread of the same nominal size (not interchangeable)

Pipe this thread is cut on

All Pipe Threads sizes

Compare all 28 sizes in the Pipe Threads chart →

Sources

  1. ASME B1.20.1: Pipe Threads, General Purpose, Inch
  2. ISO 228-1:2000, Pipe threads where pressure-tight joints are not made on the threads
  3. ISO 7-1:1994, Pipe threads where pressure-tight joints are made on the threads
  4. Engineers Edge: Whitworth pipe thread (DIN ISO 228) tap drill table
  5. Machining Doctor: NPT thread charts (B1.20.1 basic dimensions)

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.