225S Motor Frame Dimensions

Motor Frame Sizes · IEC 60072-1 (mm)

The 225S frame (IEC 60072-1, mm) has a shaft height of 225 mm (8.858 in) and a 60 mm (2.362 in) shaft 140 mm (5.512 in) long. Foot holes: 356 mm (14.016 in) across × 286 mm (11.260 in) along, the first one 149 mm (5.866 in) from the shaft shoulder; hole diameter 18.5 mm (0.728 in).

HShaft height (IEC H / NEMA D)
225 mm8.858 in8.858 in225 mm
DShaft diameter (IEC D / NEMA U)
60 mm2.362 in2.362 in60 mm
AFoot holes across (IEC A / NEMA 2E)
356 mm14.016 in14.016 in356 mm
BFoot holes along (IEC B / NEMA 2F)
286 mm11.260 in11.260 in286 mm

Drawing

Drive-end viewA = 356 mmA = 14.016 inH = 225 mmH = 8.858 in
Side viewB = 286 mmB = 11.260 inC = 149 mmC = 5.866 inE = 140 mmE = 5.512 in⌀D = 60 mm⌀D = 2.362 in
Mounting dimensions to scale for this frame; body, fan cowl and terminal box are schematic.Drawn to scale · Dimensions in mmDimensions in inches

225S specifications

HShaft height (IEC H / NEMA D)225 mm8.858 in
AFoot holes across (IEC A / NEMA 2E)356 mm14.016 in
BFoot holes along (IEC B / NEMA 2F)286 mm11.260 in
CShaft shoulder to first hole (IEC C / NEMA BA)149 mm5.866 in
KFoot bolt hole (IEC K / NEMA H)18.5 mm0.728 in
DShaft diameter (IEC D / NEMA U)60 mm2.362 in
EShaft extension (IEC E / NEMA N-W)140 mm5.512 in

Same shaft height, other foot length

Similar shaft height in the other system

All motor frames

All 48 motor frames →

Sources

  1. IEC 60072-1:2022, Dimensions and output series for rotating electrical machines, Part 1: Frame numbers 56 to 400
  2. NEMA MG 1: Motors and Generators, Part 4 (dimensions, frame designations)
  3. Regal Rexnord: Quick reference motor dimensions (NEMA frame chart)
  4. Motion Industries: NEMA quick reference chart
  5. Electric Motor Warehouse / Drive Centre: IEC quick reference dimensional charts
  6. ABB / WEG / Brook Crompton low-voltage motor catalogues: IEC dimension tables

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.