365T Motor Frame Dimensions

Motor Frame Sizes · NEMA MG 1 (inch)

The 365T frame (NEMA MG 1, inch) has a shaft height of 9 in (228.6 mm) and a 2 3/8 in (60.3 mm) shaft 5 7/8 in (149.2 mm) long. Foot holes: 14 in (355.6 mm) across × 12 1/4 in (311.2 mm) along, the first one 5 7/8 in (149.2 mm) from the shaft shoulder; hole diameter 21/32 in (16.7 mm).

HShaft height (IEC H / NEMA D)
228.6 mm9 in9 in228.6 mm
DShaft diameter (IEC D / NEMA U)
60.3 mm2 3/8 in2 3/8 in60.3 mm
AFoot holes across (IEC A / NEMA 2E)
355.6 mm14 in14 in355.6 mm
BFoot holes along (IEC B / NEMA 2F)
311.2 mm12 1/4 in12 1/4 in311.2 mm

Drawing

Drive-end view2E = 355.6 mm2E = 14 inD = 228.6 mmD = 9 in
Side view2F = 311.2 mm2F = 12 1/4 inBA = 149.2 mmBA = 5 7/8 inN-W = 149.2 mmN-W = 5 7/8 inU = 60.3 mmU = 2 3/8 in
Mounting dimensions to scale for this frame; body, fan cowl and terminal box are schematic.Drawn to scale · Dimensions in mmDimensions in inches

365T specifications

HShaft height (IEC H / NEMA D)228.6 mm9 in
AFoot holes across (IEC A / NEMA 2E)355.6 mm14 in
BFoot holes along (IEC B / NEMA 2F)311.2 mm12 1/4 in
CShaft shoulder to first hole (IEC C / NEMA BA)149.2 mm5 7/8 in
KFoot bolt hole (IEC K / NEMA H)16.7 mm21/32 in
DShaft diameter (IEC D / NEMA U)60.3 mm2 3/8 in
EShaft extension (IEC E / NEMA N-W)149.2 mm5 7/8 in

Same shaft height, other foot length

Similar shaft height in the other system

All motor frames

All 48 motor frames →

Sources

  1. IEC 60072-1:2022, Dimensions and output series for rotating electrical machines, Part 1: Frame numbers 56 to 400
  2. NEMA MG 1: Motors and Generators, Part 4 (dimensions, frame designations)
  3. Regal Rexnord: Quick reference motor dimensions (NEMA frame chart)
  4. Motion Industries: NEMA quick reference chart
  5. Electric Motor Warehouse / Drive Centre: IEC quick reference dimensional charts
  6. ABB / WEG / Brook Crompton low-voltage motor catalogues: IEC dimension tables

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.