H7/k6 Fit Tolerances

ISO Fits · Hole-basis fits (H hole)

H7/k6: Transition fit, Hole-basis fits (H hole). At ⌀25 mm the hole is +21 / 0 µm, the shaft +15 / +2 µm, giving a maximum clearance of 19 µm and a minimum clearance of −15 µm (negative = interference). The table below lists the limits for every ISO size range up to 500 mm.

Fit type
Transition
Max. clearance at ⌀25 mm
19 µm0.00075 in0.00075 in19 µm
Min. clearance at ⌀25 mm (− = interference)
−15 µm−0.00059 in−0.00059 in−15 µm

Drawing

zero line = nominal sizeHole H7Shaft k6+210+15+2⌀25 H7/k6: clearance up to 19 µm, interference up to 15 µm
Tolerance zones at ⌀25 mm, deviations in µm; vertical scale enlarged.Proportions shown, not to scale

H7/k6 specifications

Fit typeTransition
Hole limits at ⌀25 mm (µm)+21 / 0
Shaft limits at ⌀25 mm (µm)+15 / +2
Max. clearance at ⌀25 mm19 µm0.00075 in
Min. clearance at ⌀25 mm (− = interference)−15 µm−0.00059 in

H7/k6 limits for every size range (µm)

Size (mm)Hole ES / EIShaft es / eiMax. clearanceMin. clearanceType
≤ 3+10 / 0+6 / 0+10−6transition
3–6+12 / 0+9 / +1+11−9transition
6–10+15 / 0+10 / +1+14−10transition
10–18+18 / 0+12 / +1+17−12transition
18–30+21 / 0+15 / +2+19−15transition
30–50+25 / 0+18 / +2+23−18transition
50–80+30 / 0+21 / +2+28−21transition
80–120+35 / 0+25 / +3+32−25transition
120–180+40 / 0+28 / +3+37−28transition
180–250+46 / 0+33 / +4+42−33transition
250–315+52 / 0+36 / +4+48−36transition
315–400+57 / 0+40 / +4+53−40transition
400–500+63 / 0+45 / +5+58−45transition

Transition fit, about equally likely to be tight or loose: gears and couplings on shafts with a key, bearing inner rings on rotating shafts. Assembled with a mallet or light press.

Other fits of the same type (Transition)

All ISO fits

Compare all 24 fits in the ISO Fits chart →

Sources

  1. ISO 286-1:2010, Geometrical product specifications (GPS): ISO code system for tolerances on linear sizes, Part 1: Basis of tolerances, deviations and fits
  2. ISO 286-2:2010, Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
  3. ANSI B4.2-1978 (R2020): Preferred metric limits and fits

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.