H8/h7 Fit Tolerances

ISO Fits · Hole-basis fits (H hole)

H8/h7: Clearance fit, Hole-basis fits (H hole). At ⌀25 mm the hole is +33 / 0 µm, the shaft 0 / −21 µm, giving a maximum clearance of 54 µm and a minimum clearance of 0 µm (negative = interference). The table below lists the limits for every ISO size range up to 500 mm.

Fit type
Clearance
Max. clearance at ⌀25 mm
54 µm0.00213 in0.00213 in54 µm
Min. clearance at ⌀25 mm (− = interference)
0 µm0.00000 in0.00000 in0 µm

Drawing

zero line = nominal sizeHole H8Shaft h7+3300−21⌀25 H8/h7: clearance 0 to 54 µm
Tolerance zones at ⌀25 mm, deviations in µm; vertical scale enlarged.Proportions shown, not to scale

H8/h7 specifications

Fit typeClearance
Hole limits at ⌀25 mm (µm)+33 / 0
Shaft limits at ⌀25 mm (µm)0 / −21
Max. clearance at ⌀25 mm54 µm0.00213 in
Min. clearance at ⌀25 mm (− = interference)0 µm0.00000 in

H8/h7 limits for every size range (µm)

Size (mm)Hole ES / EIShaft es / eiMax. clearanceMin. clearanceType
≤ 3+14 / 00 / −10+240clearance
3–6+18 / 00 / −12+300clearance
6–10+22 / 00 / −15+370clearance
10–18+27 / 00 / −18+450clearance
18–30+33 / 00 / −21+540clearance
30–50+39 / 00 / −25+640clearance
50–80+46 / 00 / −30+760clearance
80–120+54 / 00 / −35+890clearance
120–180+63 / 00 / −40+1030clearance
180–250+72 / 00 / −46+1180clearance
250–315+81 / 00 / −52+1330clearance
315–400+89 / 00 / −57+1460clearance
400–500+97 / 00 / −63+1600clearance

Locational clearance fit with wider tolerances than H7/h6: simple centring of stationary parts, pulleys and collars with a key or set screw.

Other fits of the same type (Clearance)

All ISO fits

Compare all 24 fits in the ISO Fits chart →

Sources

  1. ISO 286-1:2010, Geometrical product specifications (GPS): ISO code system for tolerances on linear sizes, Part 1: Basis of tolerances, deviations and fits
  2. ISO 286-2:2010, Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
  3. ANSI B4.2-1978 (R2020): Preferred metric limits and fits

Values last checked against these sources on November 15, 2026. · How we check data

Reference values for planning and identification. Confirm critical dimensions with the manufacturer's drawing or the current edition of the standard before production.